Bathroom Vanity Lights up with an integrated power outlet. This outlet allows you to connect devices like electric shavers without requiring the addition of an extra outlet in the bathroom. This can be an important convenience, especially if the bathroom is old and has limited power outlets. You can install vanity lights and outlets using existing lighting wires from the old lighting. Line up these and push the light on the bolts. Place the nuts that come with vanity on the ends of the bolts and tighten them with your fingers. Turn off the power to the circuit again.
15 Photos Gallery of: Installing Bathroom Vanity Lights
Turn off the power to the circuit you will be working in the box breaker for your home. It’s very important that you never try to work on a live electrical circuit. Place the mounting plate for Bathroom Vanity Lights on the wall at the place where you plan to install the light. Screw the mounting plate into the wall with the supplied hardware and a screwdriver; make sure the electrical wires for light paths through the opening in the center of the mounting plate. Take half the insulation from the ends of the black and white wires on electrical wires using a set of wire strips.
Only place the ends of the white wire from Bathroom Vanity Lights and the white wire from electrical wires and slide wire nuts over the ends of the wires. Twist thread nut until it is firmly attached. Wrap a 3-inch piece of tape around the cables and wire nuts for extra insurance. Only place the ends of the black cable from vanity light and the black cable from electrical wires and slide wire nuts over the ends of the wires. Twist thread nut until it is firmly attached. Wrap a 3-inch piece of tape around the cables and wire nuts for extra insurance. Slide vanity light on the mounting plate. Most will have several protruding bolts corresponding to holes in vanity light.